This manual is used as the standard service manual for the Xerox WorkCentre 5016, 5020.
This service manual describes the standard procedures for servicing the WorkCentre 5016, 5020.
Contents:
This manual is divided into nine sections as described below.
1. Service Call Procedures.
This section describes the structured process for determining the type and sequence of actions that are performed during a service call.
2. Status Indicator RAPs.
This chapter contains the Repair Analysis Procedures (RAPs) necessary to repair all faults other than image quality faults.
3. Image Quality RAPs.
This section contains the Repair Analysis Procedures (RAPs) that are used to diagnose image quality defect problems.
4. Removal/Replacement and Adjustment Procedures.
This chapter contains the removal, replacement, and adjustment procedures for components of WorkCentre 5016, 5020.
5. Parts List.
This section contains a list of spare parts list for the Xerox WorkCentre 5016, 5020.
6. General Procedures/Information.
This chapter contains frequentlyused procedures that relate to the diagnosis, setup, or operation of the machine. It also contains pertinent information that will not befound in any other part of the service documentation.
7. Wiring Data.
This section contains the wiring information for the WorkCentre 5016, 5020. It contains a connector list/locator, wirenet diagrams, and Block Schematic Diagrams (BSDs) for the following chains:
1. Standby Power;
2. Mode Selection;
3. Machine Run Control;
4. Start Print Power;
6. Imaging;
7. Paper Supplying;
8. Paper Transportation;
9. Marking;
10. Fusing and Copy Transportation.
Download Xerox Work Center 5016, 5020. Service Manual